Manufacturing issue prompts FAA to propose 787 stabiliser inspections

The FAA intends to require airlines to inspect horizontal stabiliser hardware on Boeing 787s due to components possibly being assembled incorrectly by the company during manufacturing. The FAA proposed the inspections in notice released on 21 November. It says Boeing already made operators aware of the issue and recommended inspections in an “Alert Requirements Bulletin” released by the company in August. The regulator’s action responds to a report of possible “misalignment at final assembly” of horizontal stabiliser hardware – specifically, a “pivot pin lock ring, outer pivot pin and outboard spacer misalignment”. “One operator further reported a left-side pivot assembly that did not have a visible gap between the outboard nut and trap fitting,” the FAA adds. “A misaligned pivot pin lock ring caused a pivot pin outboard spacer to not be set flush against the horizontal stabiliser pivot bearing and outboard washer.” The result can be “decreased lateral load capacity”, possibly leading to “loss of pivot pin retention parts… [which] could result in the loss of the horizontal stabiliser.”<br/>